Table of Contents
Advertisement
Table 3-61 Features Supported in Framesync Mode, Delay Mode, and Demux-Only Mode
Processing Feature
Audio Sync
Audio Delay
Audio ProcAmp
Bypass Mode
Upgrading the firmware on PT-FSDMX-IBG module takes approximately 50 minutes.
Multiple (identical) boards can be upgraded at once in batches of up to 16 boards (= one
'zone'). A 'batch' upgrade takes about as long as upgrading a single board.
Always wait for the 'Firmware upgrade successful' message before power-cycling the
system, exchanging boards, or carrying out any other maintenance work that could
interfere with the upgrade process. Do not interrupt the power supply or tamper with a
board while an upgrade is in progress. This could corrupt the firmware, necessitating a
restart of the upgrade process.
Note: If the Software Version shows 0.00, this indicates that the PT-FSDMX-IBG is in failsafe
mode. In this mode, the board will only support upgrade operations and basic control with
the Platinum Resource module. You can perform software upgrades as usual while the
module is in failsafe mode, but after the upgrade is completed, the module will need to be
hot-swapped in order to have the new firmware take effect.
Functional Block Diagram
This diagram shows the video and audio data paths for a single channel through the
module. This path is duplicated for each of the module's eight channels.
Video
Installation, Configuration, and Operation Manual
Embedded Audio
TDM Audio
FS
FS
FS, DMX
FS, DLY, DMX
FS, DMX
FS, DLY, DMX
FS, DLY, DMX
Platinum Frames and Modules
183
Advertisement
Table of Contents
