Table of Contents
Advertisement
152
Chapter 3
Input Modules
Electrical Back Module
The electrical back module is an active back module attached to the front module with two
brackets and with Cable Equalizers. The back module has four BNC connectors and stays
attached to the front module when pulling the module from the frame. The back module is
fully MADI compliant in terms of its electrical characteristics.
Figure 3-44 PT-MADI4C-IBG electrical back module
Optical Back Module
The optical back module hosts the cages for up to four Dual-Rx Small Form-factor Pluggable
(SFP) Fiber Optic Receivers. In connection with the PT-MADI-IBG front module, only two of
the four 'cages' will be used. The back module has to be mounted onto the Platinum frame
and the Front Module detaches from the Back Module when the Front Module is pulled out
from the frame. One Dual-Rx SFP module is pre-installed. The SFP module complies with the
AES10-2008 requirements for optical interfaces. See
details.
Figure 3-45 PT-MADI4O-IBG optical back module
PT-MADI4O-IBG Specifications
for
Advertisement
Table of Contents
