Table of Contents
Advertisement
Manual mode: manually sets a 270 Mb/s rate for reclocking
Bypass mode: data bypasses the PLL
Mute mode: no output at the output pins of the reclocker
Output data from the reclocker is fed to a 75 output driver feeding the 75 BNC. An 8×1
differential crosspoint selects the output monitoring signal.
Back Panel I/O Module for PM-SR-OB+/PT-SR-OB
The PT-V-BP back panel I/O module corresponds to the PM-SR-OB+ and PT-SR-OB+ modules.
Submodules
PT-MX-SB
The optional PT-MX-SB submodule corresponds to the PM-SR-OB+ and PT-SR-OB+
modules. See page 285 for more information.
Note: Modules marked as PM-SR-OB+DX are PM-SR-OB+ modules equipped with
PT-MX-SB submodules. Modules marked as PT-SR-OB+DX are PT-SR-OB+ modules equipped
with PT-MX-SB submodules
Installation
Output Module Installation
All output modules are installed at our manufacturing facility. See
Information for Upgrading 3 Gb Input, Output, and Crosspoint Module Firmware
on page 357 and
for field expansion or replacement of output modules. If you need to purchase additional
components, please contact your dealer or our Sales Department.
Back Panel I/O Module Installation
All back panel modules are installed at our manufacturing facility. See
Panel Modules
If you need to purchase additional components, please contact your dealer or our Sales
Department.
Configuration
This module requires no additional configuration procedures besides those described for
frame configuration.
Installing Input and Output Modules
on page 372 for the procedure for field expansion of back panel modules.
Platinum Frames and Modules
Installation, Configuration, and Operation Manual
Special Pre-Installation
on page 361 for the procedure
Installing Back
237
Advertisement
Table of Contents
