Table of Contents
Advertisement
254
Chapter 4
Output Modules
Configuration
Controllable Parameters
Table 4-24 PM-AEBT-OB/PM-AECT-OB/PT-AEBT-OB/PT-AECT-OB User-Controllable
Parameters List
[RO] = Read-only parameter
Parameter
Back Module Type
Tone (1-16)
XPT Type
Disconnect State
Polarity Reversal (1-32)
Lock Detect (1-16) [RO]
Phase Alarm (1-16)
Back Panel I/O Module Installation
All back panel modules are installed at our manufacturing facility. See
Panel Modules
on page 372 for the procedure for field expansion of back panel modules.
If you need to purchase additional components, please contact your dealer or our Sales
Department.
This module requires no additional configuration procedures besides those described for
frame configuration.
Table 4-24
lists the user-controllable parameters for the PM-AEBT-OB, PM-AECT-OB,
PT-AEBT-OB, and PT-AECT-OB modules. These parameters are accessible via either
RouterMapper or CCS Navigator. In RouterMapper, parameters are found in the Configure
Module Parameters and/or Module Parameters list boxes. In Navigator, when in control
mode, double-click on the device name to open a window that displays that device's
parameter list.
See the appropriate reference manual for information on how to set these parameters.
Description
Reports coax or balanced back
module
Indicates type of tone to send out
AES output
Determines crosspoint matrix
requirement
Select whether to transmit AES
silence or a DC level when signal
presence is lost
Reverses + and - to correct audio
polarity in the analog domain
Reports if data is re-locked by
reclocking stage
Alarm set if right and left channels
are out of phase
Installing Back
Options
PT-AEBT-BMO
PT-AECT-BMO
PT-AEB-BMO
PT-AEC-BMO
Pass input
Silence
500 Hz
1 K
TDM XPT
Wideband
Silence
DC
Normal polarity
Invert polarity
Not locked
Locked
No phase error
Phase error
Advertisement
Table of Contents
