Snom M100 KLE Administrator And Provisioning Manual page 70

Setting
Static IP
IP Address
Subnet Mask
Gateway
PPPoE
Username
Password
Manually Configure DNS
Primary DNS
Secondary DNS
IPv6
Setting
Disable
Auto Configuration
Static IP
IP Address
Prefix (0–128)
Gateway
Manually Configure DNS
Primary DNS
Secondary DNS
Using the WebUI
M100 KLE Administrator and Provisioning Manual
Description
When Static IP is selected, you must enter a static IP
address for the M100 KLE, as well as addresses for the
Subnet Mask, Gateway, and DNS Server(s).
If DHCP is disabled, enter a static IP address for the M100
KLE.
Enter the subnet mask.
Enter the address of the default gateway (in this case, your
router).
Select to enable PPPoE (Point-to-Point Protocol over
Ethernet) mode.
Enter your PPPoE account username.
Enter your PPPoE account password.
Select to enable manual DNS configuration.
If DHCP is disabled, enter addresses for the primary and
secondary DNS servers.
Description
Disables all related IPv6 settings.
Auto configuration is selected (enabled) by default, which
means the M100 KLE will get its IP address, Gateway, and
DNS Server(s) from the network. When Auto Configuration is
disabled, you must enter a static IP address for the M100
KLE, as well as addresses for the Gateway and DNS
Server(s).
When Static IP is selected, you must enter a static IP
address for the M100 KLE, as well as an IPv6 address
prefix, Gateway, and DNS Server(s).
If Auto Configuration is disabled, enter a static IP address for
the M100 KLE.
Enter the IPv6 address prefix length (0 to 128 bits).
Enter the address of the default gateway (in this case, your
router).
Select to enable manual DNS configuration.
If Auto Configuration is disabled, enter addresses for the
primary and secondary DNS servers.
70
Back to Contents