Using The Network Setting Menu - Snom M100 KLE Administrator And Provisioning Manual

Using the Network Setting menu

Use the Network setting menu to configure network-related settings for the M100 KLE. For
more information about these settings, see
"Advanced Network Settings" on page
To use the Network setting menu:
1. From the Admin Settings menu, press
then press MENU/SELECT.
The Network setting menu appears.
2. Press
Network setting
DHCP
Set static IP
VLAN ID
Others
BACK
DHCP

Set static IP

VLAN ID

Others (DNS and NTP servers).

To enable or disable DHCP:
1. From the Network setting menu, press
MENU/SELECT.
The DHCP screen appears.
2. Press
DHCP is enabled by default, which means the M100 KLE will get its IP address from the
network. When DHCP is disabled, you must enter a static IP address for the M100 KLE.
Configuration Using the Phone Menus
 
or to highlight the desired option, and then press MENU/SELECT:
ENTER
 
to select Enabled or Disabled, and then press
or
M100 KLE Administrator and Provisioning Manual
"Basic Network Settings" on page 69
71.
 
to highlight Network setting, and
or
 
to highlight DHCP, and then press
or
25
and
SET .
Back to Contents