Snom M100 KLE Administrator And Provisioning Manual page 66

Setting
Off Hook
Incoming Call
Outgoing Call
Timer Based
Timer Based Interval
Connected
Registration Event
Using the WebUI
M100 KLE Administrator and Provisioning Manual
Description
The Off Hook URI is triggered when the user goes to Dial
mode by:
Lifting the handset

Pressing the SPEAKER hard key

Pressing the [New] soft key during a held call.

Note that the Off Hook URI will NOT be triggered when
calling a pre-defined number and going immediately to
Dialling mode—this event triggers the Outgoing Call URI
instead.
The Incoming Call URI is triggered for each Incoming Ring
event or Call Waiting event. Using the Incoming Call URI, it is
possible to display extra information on the phone for an
Incoming Call. For example, the XML application that is
called when there is an Incoming Call can do a database
lookup and display information on the caller.
Note that this Action URI will not be triggered if DND or Call
Forward All is enabled or if Call Waiting is disabled (i.e., the
call is rejected).
The Outgoing Call URI is triggered each time a SIP INVITE
message is sent (Dialling mode). For example, after:
Pressing the
Dial

populated number
Using the dial pad to speed dial a call

Dialling a Directory number by going off-hook.

The Timer Based URI will be triggered when the configured
timeout expires. The timer starts at the end of the phone boot
sequence.
Enter the interval before the Timer Based URI is triggered.
The Connected URI is triggered each time the phone is in an
Active Call or is Paging.
The Registration Event URI is triggered every time there is a
registration state change. For example:
Registered

Deregistered

Fail (Registration timed out, refused, or expired)

The Registration Event URI is not triggered when the same
event is repeated.
66
key in Pre-Dial with
Back to Contents