Jitter Buffer; Keep Alive - Snom M100 KLE Administrator And Provisioning Manual

Setting
Maximum Value (secs)

Jitter Buffer

Setting
Fixed
Fixed Delay (ms)
Adaptive
Normal Delay (ms)
Minimum Delay (ms)
Maximum Delay (ms)

Keep Alive

Setting
Enable Keep Alive
Keep Alive interval
(secs)
Using the WebUI
M100 KLE Administrator and Provisioning Manual
Description
Sets the session timer maximum value (in seconds) for
account x.
Description
Enable fixed jitter buffer mode.
If Fixed is selected, enter the fixed jitter delay.
Enable adaptive jitter buffer mode.
If Adaptive is selected, enter the normal or "target" delay.
Enter the minimum delay.
Enter the maximum delay. This time, in milliseconds, must
be at least twice the minimum delay.
Description
Enable SIP keep alive in service of NAT traversal and as a
heartbeat mechanism to audit the SIP server health status.
Once enabled, OPTIONS traffic should be sent whenever
the account is registered. OPTIONS traffic will occur
periodically according to the keep-alive interval.
Set the interval at which the OPTIONS for the keep-alive
mechanism are sent.
51
Back to Contents