Resynchronization: Configuration File Checking; M100 Kle Restart - Snom M100 KLE Administrator And Provisioning Manual

Resynchronization: configuration file checking

You can select a number of options that determine when the M100 KLE checks for new
configuration files. This process of checking for configuration files is called
Resynchronization. Resynchronization options are available on the WebUI Provisioning
page, but you can also include them in a configuration file.
The resynchronization options are:
Mode—sets the M100 KLE to check for a configuration file only, a firmware update

file only, or both types of file.
Never—configuration file checking is disabled

Bootup—the M100 KLE checks for new configuration files when it boots up. Any

updates are applied during the boot-up process.
Remote check-sync—enables you to start a resynchronization remotely using your

hosted server's web portal. The Remote check-sync settings are available only in
the configuration file, not the WebUI.
Repeatedly, at a defined interval from 60 to 65535 minutes (45 days).


M100 KLE restart

If the M100 KLE needs to restart after an auto-update, the restart happens only after the
device has been idle for one minute.
To prevent users from delaying the update process (auto-updates cannot begin until the
M100 KLE has been idle for one minute), or to avoid device restarts that might interfere with
incoming calls:
set the resynchronization interval to a suitable period

upload any new configuration file(s) to your provisioning server after work hours so

that the M100 KLE will download the file(s) when there is no call activity.
When you update the M100 KLE by importing a configuration file using the WebUI, the
device restarts immediately after applying the new settings, regardless of whether the
M100 KLE is idle.
Provisioning Using Configuration Files
M100 KLE Administrator and Provisioning Manual
111
Back to Contents