Warnings/Error Signals - Otto Bock C-Brace Instructions For Use Manual

Appendices
Beep signal

17.2.2 Warnings/error signals

Error during use
Beep signal
3 x long
5 x long
10x long, then switching
to empty battery mode
Beep signal
1 x short at intervals of
approx. 1 second
Ongoing short beep sig­
nal
Ongoing short beep sig­
nal
Continuous beep signal
Error while charging the product
LED on LED on
power sup­ battery
ply charger
82
Additional action performed
Event
Battery charge level under 10 %
Battery charge level under 5 %
Battery charge level approx. 1 %
Event
Overheated hydraulic unit
Error of moderate severity:
e.g. a sensor is not operational
Switch to safety mode
Walking possible with restrictions
Loss of spring contact/loss of sensor
screw contact
Active safety mode
Walking possible with restrictions
Severe error:
e.g. failure of valve drives
Possibly no switching into safety mode
Undetermined product behaviour
Total failure:
Electronic control no longer possible
Safety mode active or undetermined valve
state
Undetermined product behaviour
Error
Country-specific plug adapter not fully
engaged on power supply
Non-functional wall socket
Event
Check the following points:
• Was weight put on the leg with the
product or was there movement in the
knee joint?
• Is the spring element in the foot
region bent and therefore defective?
• Was calibration performed?
Required action
Reduce activity
Attempt to reset this error by connecting
the battery charger. If this error persists,
the product must be inspected by an
authorised Ottobock Service Centre.
The beep signal can be muted by press­
ing the top button on the joint unit (5
seconds).
Restore contact with the spring or sensor
screw. By pressing the top button on the
joint unit (5 seconds), check the sensor
contact. The check is confirmed by a long
beep signal.
If this error persists, the product must be
inspected by an authorised Ottobock Ser­
vice Centre.
The product must be inspected by an
authorised Ottobock Service Centre
The product must be inspected by an
authorised Ottobock Service Centre
The product must be inspected by an
authorised Ottobock Service Centre
Resolution
Check whether the country-specific plug
adapter is fully engaged on the power
supply.
Check wall socket with another electric
appliance.
C-Brace