Connecting The Power Supply And Battery Charger; Connect Battery Charger To The Product; Display Of The Current Charge Level; Preparation For Use - Otto Bock C-Brace Instructions For Use Manual

6.1 Connecting the power supply and battery charger

1
1) Slide the country-specific plug adapter onto the power supply until it locks into place (see fig. 1).
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery charger so that the
plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery charger so that
the plug locks into place (see fig. 2).
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger light up (see
fig. 3).
→ If the green LED on the power supply and the green LED on the battery charger do not light up, there is an
error (see Page 82).

6.2 Connect battery charger to the product

6.3 Display of the current charge level

The current battery charge level can only be displayed by connecting the battery charger and power supply to the
product.
Battery
charger
Battery charge level less than 50%
Battery charge level over 50%
Battery is fully charged

7 Preparation for use

7.1 C-Brace orthosis with spring element

The following steps need to be carried out the first time the product is put on and adjusted:
C-Brace
2
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the product.
INFORMATION: Take note of the plug direction!
→ The correct connection of the battery charger to the product is indicated by
feedback (Status signals).
3) The charging process starts.
→ After approx. 6 hours, the product battery is fully charged and the yellow
LED on the battery charger turns off.
4) Disconnect the product after the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by feedback
(Status signals).
5) Close the charging receptacle cover.
Preparation for use
3
59