Adjustment With C-Soft; Introduction; Indications For Use; Installation - Otto Bock C-Brace Instructions For Use Manual

17) Adapt the values in the software depending on the patient (see Page 64).
18) Save the configured values and disconnect the product from the software.

8 Adjustment with C-Soft

8.1 Introduction

The "C-Soft" adjustment software makes it possible to optimise the product settings for a patient. The adjustment
software provides step-by-step guidance through the adjustment process. After the settings are configured, the
data for them can be saved and printed for documentation. If needed, these data can be loaded and fed into the
product.

8.2 Indications for use

The "C-Soft" adjustment software is intended for the patient-specific adjustment of the following products:
• Leg orthosis with 17B300=* C-Brace joint module
• Electronic knee joint systems with the article numbers: 3C95/3C85, 3C96/3C86, 3C96-1/3C86-1, 3C98/3C88,
3C98-1/3C88-1, 3C98-2/3C88-2.

8.3 Installation

For the installation/removal of C-Soft, please read the 647G268 instructions for use.

8.4 Data transfer between the product and the PC

Product settings using the adjustment software can only be made via Bluetooth data transfer. For this, a Bluetooth
wireless connection must be established between the product and the PC with the help of the 60X5 BionicLink
PC. To install the 60X5 BionicLink PC for the first time, follow the procedure described in the instructions for use
supplied with this adapter.
INFORMATION
Do not disconnect the 60X5 BionicLink PC from the PC when there is an active Bluetooth connection.
INFORMATION
Secure data transfer is only assured up to a distance of 10 m between the BionicLink PC and the product.

8.4.1 BionicLink

INFORMATION
Prior to connecting the 60X7 BionicLink, read the corresponding instructions for use.
1) Open the plug cover.
2) Connect the cable of the BionicLink to the lower receptacle.
→ The blue LED on the BionicLink has to light up. If it does not, charge the product battery or check the con­
necting cable.
3) Attach the BionicLink to the joint module using the hook-and-loop closure.
C-Brace
Adjustment with C-Soft
61