Switching Modes With The Buttons On The Hydraulic Unit; Activating The Additional Mode (2Nd Mode) - Otto Bock C-Brace Instructions For Use Manual

Use

9.4.1 Switching modes with the buttons on the hydraulic unit

Symbol guide
Press bottom button 1x
long
Press top button 1x
long
Press bottom button 2x
short
Short beep signal
Long beep signal
Relieve load on leg
Table – mode switching
from to Press top button
1st 2nd
1st LOM
2nd 1st
2nd LOM
LOM 1st
LOM 2nd
INFORMATION
If 4 short beep signals are emitted, this means switching could not be completed. The most frequent cause of this
is that the weight was not taken off the leg after the first beep signal.

9.4.2 Activating the additional mode (2nd mode)

INFORMATION
Before the first step, always check whether the selected mode corresponds to the desired motion type.
74
Upper button ( ) – return to basic mode (1st mode)
Lower button ( ) – switching to the additional mode (2nd mode) and LOM
INFORMATION: With the exception of the basic mode (1st mode),
some movement patterns are limited or not possible in all other
modes.
Overview – mode switching
Press bottom
( ) button ( )
1 x long
2 x short
1 x long
2 x short
1 x long
1 x long
Beep signal Additional action
1 x long Relieve load on leg
3 x short
1 x long Relieve load on leg
1 x long Relieve load on leg
1 x long Relieve load on leg
1 x long Relieve load on leg
Beep signal
2 x short
1 x short
3 x short
1 x short
2 x short
C-Brace