Port Properties And Settings; Common Features; Input Cable Equalization - Lightware MX-FR Series User Manual

   
6. Software Control – Lightware Device Controller Software
6.5. Port Properties and Settings
Press the desired port button on the port bar on the right.
INFO:
Port settings of the selected port are also available by pressing the Parameters button.
Click on the number of the desired port in the case of grid view or on the headline of the port in the case of
tile view to open the port properties window. Signal status information and the most important parameters
are displayed. Audio mode, HDCP settings, properties of the test pattern are available from this menu. If
analog audio is present, the user can set the volume, balance and gain values here. Special functions (e.g.
frame detector, switching this input to all outputs, etc) are also available on the panel.
AAAENAIONG!
As the available settings and features are different port by port the content of the Port
properties window is also different.
6.5.1. Common Features
Scope of Changes
There are two options to apply changes. To set the scope of the changed settings, select the desired option.
Apply changes to current input: the modified parameters are applied to the current port.
▪
▪ Apply changes to all inputs: the modified parameters are applied to all input ports.
INFO:
When opening the window again, the selection will be set to "Current Input" regardless of the active
selection at the time of closing to avoid making changes to all inputs by mistake.
Reload Factory Defaults
▪ Current input: Reloads the default values to the currently selected input.
▪ All inputs: Loads the factory default values to all inputs.
Port Name
The port name can be changed by typing the new name and clicking the Rename button.
Switch this Input to all Outputs
This input will be router to all of the outputs. Before switching the actual crosspoint state can be saved as
a Preset.
HDCP Enable (input ports)
The HDCP capability can be enabled or disabled on the input port. This can prevent unnecessary HDCP
encryption with certain source devices. Note that only unprotected contents can be played on the source if
this setting is disabled (unchecked). See the

Input Cable Equalization

The amplitude of high-frequency signals decreases after they pass-through long distances in copper cables.
To counter-act this phenomenon, certain input boards can amplify the signal while maximizing the amplitude
at a certain level, which is defined by the DVI 1.0 standard. This process is called equalization.
HDCP Management section for more information.
MX-FR Series Modular Matrix Frames – User's Manual
There are two equalization modes: automatic and manual. Automatic mode usually provides perfect
transmission but at longer distances and higher resolutions, manual equalization may be necessary. By
Parameters
default, automatic equalization is enabled.
Ceep in mind that a previously set manual equalization level may not be suitable for a different system. It is
always advised to use the automatic mode and adjust the equalization manually if the auto mode does not
give a good result.
Serial Port Extension Parameters (HDMI-OPT boards)
Supported Boards:
▪ MX-HDMI-OPT-IB, -OB, -OB-R
This is the RS-232 commands over fiber function, which is described in the
section. It allows the serial commands to be sent over the fiber cable. It is recommended to disable this
feature if not used. If the far optical device supports this protocol the Serial passthrough can be enabled.
Click on the drop-down menu, then select the Dnable option.
The Serial link shows the actual status of the function. If the function is supported by the transmitter and it
is enabled the status is "Live" otherwise the "TX/RX not detected" text can be seen.
RS-232 Command Transmission
RS-232 Terminal (MX-HDMI-OPT-OB-R-SC board)
58