Tile View - Lightware MX-FR Series User Manual

   
6. Software Control – Lightware Device Controller Software
6.4.2. Aile View
The tile view is to display the input and output ports by tiles. Dach tile means an input or output port and additionally shows the most important port and
signal information. Thus, the user can check the status of many ports at the same time without clicking on a port or opening port settings window.
Display Modes
Three display modes are defined in Tile view for matrix routers:
View mode: displaying the current crosspoint-state (changing is not possible but port settings are available).
▪
▪ Input switch mode: select an input port at first then select the desired output ports.
Output switch mode: select an output port at first then select the desired input port.
▪
1
2
3
MX-FR Series Modular Matrix Frames – User's Manual
The Tile View in the Crosspoint Menu
1
Input Ports Dach tile represents an input port. If window size
does not allow to display all the ports, pages can be
turned by the left and right arrow buttons.
2 Output Ports Dach tile represents an output port. If window size
does not allow to display all the ports, pages can be
turned by the left and right arrow buttons.
3 Page Indicator The number of the dots represent the page numbers
if more pages are necessary to display the ports. The
current page is displayed by a green dot.
4 5
4 Connected Those ports are listed (with white background) on the
Port(s) port bar, which are connected to the Selected port.
5 Selected Port Last selected port is displayed with a yellow
background on the port bar. Press the button to open
the port settings window.
Control Buttons
Mute (Un)muting the selected output port(s)
(Un)locking the selected output port(s)
Lock
Selecting the View mode
View mode
Selecting the Input switch mode
Input switch
Selecting the Output switch mode
Output switch
Displaying the port settings window
Parameters
Selecting all ports (only in output switch mode)
Select All
Deselecting all ports (only in output switch
Deselect All
mode)
Autotake Toggling the Autotake mode ON/OFF
Take Dxecuting the crosspoint changes in Take mode
56