Mx-Fr9 - Lightware MX-FR Series User Manual

   
3. Product Overview
3.11. MX-FR9
Front View
7
5
6
8
1 USB control USB connection for Lightware
Device Controller software.
2 Menu Displays status information
display and menu operation.
3 Menu Arrows, escape, and enter
navigation buttons for menu navigation.
Status LEDs CPU live LDD blinks to indicate
4
normal operation. Power LDD
lights green when the router is
powered on.
Control lock Press long to disable or enable
5
front panel buttons. When red
is illuminated, all operations
on front panel are prohibited.
6 Output lock Locks one (or more) outputs.
Inhibits accidental
changing on protected output.
7 Source Select an input or preset or to
buttons view the selected input's state.
1 2 3 4
8 Destination Destination buttons can be
buttons used to select an output, or
view the selected output's
state.
9 Aake / Auto Displays the actual switching
mode (TACD or AUTOTACD).
Long press toggles
switching mode, short press
executes switching in TACD
mode.
q Preset Load preset: apply a previously
buttons saved crosspoint preset from
one of the preset memories.
Save preset: stores actual
crosspoint state, in one of the
preset memories.
w EDID mode Switches the Menu display
input
to DDID menu allowing DDID
switch, DDID save etc.
Signal Displays live sources and
e
present attached sinks on source and
destination buttons.
MX-FR Series Modular Matrix Frames – User's Manual
9
q
q
e
w
w
e
1 Status LEDs
2 DIP settings Special settings can be made
3 Alarm out
the
Preview
4
output
Aest input
5
Serial port
6
12 3 4 5
LDD indicators for internal DC 7 Ethernet
power voltages and alarm. port
with these switches.
Standard SMPTD 269M alarm
output with BNC connector.
See the Alarm Output section
for more information.
8 Reset
button
DVI output connector, which is
directly connected to the 80th
output. See the DVI Inputs and
Outputs and the Test Input
9 CPU live
and Preview Output sections
for more information.
q Output
DVI input connector, which can
boards
be configured as an alternative
for the 80th input. See the DVI
Inputs and Outputs and the Input boards Modular input board slots.
w
Test Input and Preview Output
sections.
9 pole D-SUB female connector Power
e
for RS-232 serial connection.
See the RS-232 Ports section
for more information.
22
6 7 8
9
Locking RJ45 connector.
Remote control port for
connecting the unit to Local
Area Network (LAN) and
firmware upgrade can be also
performed over this interface.
See the Dthernet Ports section
for more information.
Reset button reboots the
matrix. This is same as
disconnecting from power
source, and reconnect again.
CPU live LDD blinks to indicate
normal operation.
Modular output board slots.
Connect DVI sink devices to
these connectors.
Connect DVI source devices
to these connectors.
Mains switch and AC power
connector.