Mx-Fr17 - Lightware MX-FR Series User Manual

   
3. Product Overview
3.10. MX-FR17
Front View
7
5
6
8
1 USB control USB connection for Lightware
Device Controller software.
2 Menu Displays status information
display and menu operation.
Menu Arrows, escape, and enter
3
navigation buttons for menu navigation.
4 Status LEDs CPU live LDD blinks to indicate
normal operation. Power LDD
lights green when the router is
powered on.
5 Control lock Press long to disable or
enable front panel buttons.
When red is illuminated, all
operations on the front panel
are prohibited.
6 Output lock Locks one (or more) outputs.
Inhibits accidental
changing on protected output.
7 Source Select an input or preset or to
buttons view the selected input's state.
1 2 3 4
8 Destination Destination buttons can be
buttons used to select an output, or
view the selected output's
state.
9 Aake / Auto Displays the actual switching
mode (TACD or AUTOTACD).
Long press toggles
switching mode, short press
executes switching in TACD
mode.
Preset Load preset: apply a previously
q
buttons saved crosspoint preset from
one of the preset memories.
Save preset: stores actual
crosspoint state, in one of the
preset memories.
EDID mode Switches the Menu display
w
to DDID menu allowing DDID
input
switch, DDID save etc.
Signal Displays live sources and
e
present attached sinks on source and
destination buttons.
MX-FR Series Modular Matrix Frames – User's Manual
Rear View
9
q
q
e
w
w
e
1 Status LEDs
2 DIP settings Special settings can be made
Alarm out
3
the
Preview
4
output
Aest input
5
6 Serial port
1 23 4 5 6
LDD indicators for internal DC 7 Ethernet
power voltages and alarm. port
with these switches.
Standard SMPTD 269M alarm
output with BNC connector.
See the Alarm Output section
8 Reset
for more information.
button
DVI output connector, which is
directly connected to the 80th
output. See the DVI Inputs and
9 CPU live
Outputs and the Test Input
and Preview Output sections
for more information. Output
q
boards
DVI input connector, which can
be configured as an alternative
for the 80th input. See the DVI Input boards Modular input board slots.
w
Inputs and Outputs and the
Test Input and Preview Output
sections.
e Power
9 pole D-SUB female connector
for RS-232 serial connection.
See the RS-232 Ports section
for more information.
21
7 8
9
Locking RJ45 connector.
Remote control port for
connecting the unit to Local
Area Network (LAN) and for
firmware upgrade. See the
Dthernet Ports section for
more information.
Reset button reboots the
matrix. This is same as
disconnecting from power
source, and reconnect again.
CPU live LDD blinks to indicate
normal operation.
Modular output board slots.
Connect DVI sink devices to
these connectors.
Connect DVI source devices
to these connectors.
Mains switch and AC power
connector.