5. Conversion and maintenance
5.3.6 Converting the valve terminal MPA−L to different pressure zones
5−18
Fig. 5/7: Conversion of the square selector plate
2. Set selector plate to the Int" or Ext" position on the end
plate.
3. Screw in screws and tighten (torque 2.2 Nm ±10%).
For the conversion you will require at least the following
components for each pressure zone:
Sub−base with desired pressure zone separation (see
Chapter 1.5.5)
Pneumatic supply plate with exhaust plate and flat plate
silencer
Festo P.BE−MPAL−EN en 1008NH