Intended Use; Areas Of Application And Approval By Authorities - Festo MPA-L Series Description

Contents and general safety instructions

Intended use

Areas of application and approval by authorities

Festo P.BE−MPAL−EN en 1008NH
The MPA valve terminals are intended for fitting into a
machine or automated system and must be used exclusively
as follows:
In industrial applications
In original status without unauthorised modifications.
Only the conversions or modifications described in the
documentation supplied with the product are permitted.
In perfect technical condition
If used together with additional commercially available com
ponents, such as actuators, the specified limits for pressures,
temperatures, electrical data, torques etc. must be observed.
In addition to the safety instructions in this manual always
observe the regulations of the trade associations and the
German Technical Control Board (TÜV) and the VDE condi
tions or corresponding national conditions on−site.
The product fulfils the requirements of the EU directives and
is marked with the CE marking symbol.
Standards and test values, which the product must comply
with and fulfil, can be found in the section
data". The product−relevant EC directive can be found in the
declaration of conformity.
A.1 Technical
VII