Table of Contents
Advertisement
A.7
Setup Software for SIMATIC VS 130
The setup software is used to adjust the sensor head.
A.7.1
Requirements
•
Microsoft Windows PC (98, Me, NT 4.0, 2000 or XP)
•
Intel or compatible processor Pentium 200 MHz or faster
•
Graphics card /monitor with at least 65536 colors and a resolution of at least
640x480
•
Serial interface with 115200 Kbps supported by Windows as COM1...9. This
must be a different interface than that used by the mouse
A.7.2
Preparations
Connect the PC and the processing unit using an RS-232 null modem cable
(6ES7901-1BF00-0XA0).
Note
Establish the serial connection only when Windows has completed startup and
close the connection before restarting the PC.
If a PC is started while the processing unit is connected over the serial cable, you
may encounter problems with the mouse.
After starting the program, a message is displayed telling you that the
SIMATIC VS 130 must be in the "Setup" mode to display live pictures.
You must acknowledge this message with "OK".
After starting the program, it automatically searches for the interface to which the
processing unit is connected. This is only possible after the processing unit has
completed its self test.
Vision Sensor VS 130
A5E00199459-01
Appendix
A-17
Advertisement
Table of Contents
