Siemens SIMATIC VS130 Series Manual page 38

Operator Functions
Display Description
•
Adjust All
•
N_OK
•
OK:Finish
Note
If the processing unit has a connection to a PC with setup software, and you have
deactivated the "Read" check box in the "Options" group, the second and third
lines of the display field in the last two displays remain empty, since in this case,
there is no code localization.
No Connection to PC with Setup Software
After evaluating approximately 20 images or when you press the arrow buttons
or , the following display appears for approximately two seconds (this is called
the toggle display):
Display Description
Use ↑ and With the arrow buttons L and M, you switch between the modes "Evaluate all
images" and "Image capture only on trigger signal".
↓ to
toggle TRG
and ALL
In the "Image capture only on trigger signal" mode, the display appears, for
example as shown below:
Display Description
Adjust TRG The "Image capture only on trigger signal" is indicated by "TRG".
Read√
X:+6 Y:-1
OK:Finish
After capturing approximately 20 (triggered) images or when you press the arrow
buttons
Connection to PC with Setup Software
If you want to change over between the modes "Evaluate all images" and "Image
capture only on trigger signal", you do this with the "Triggered only" check box in
the "Options" group of the setup software (see Section A.7.3).
Note
If the connection between the processing unit and PC with the setup software is
interrupted, the same applies as explained in "No connection to PC with setup
software".
5-8
1st line: The mode "Evaluate all images" is set (Note: this is the default.).
2nd line: The code could not be localized (and therefore not read).
4th line: By pressing "OK", you exit the adjust mode.
or the toggle display appears again.
Vision Sensor VS 130
A5E00199459-01