Putting Into Operation; Turning On The Device - Siemens SIMATIC VS130 Series Manual

4

Putting into Operation

You can operate the Vision Sensor SIMATIC VS 130 interactively or controlled by
signals:
•
In this chapter, you will learn about interactive operation using the operator
control and display field of the processing unit.
•
Chapter 6 explains the options open to you with signal-controlled operation.
4.1

Turning on the Device

Turn on the power on the processing unit. The text "SIMATIC VS 130 V ..." and the
current firmware version appear on the display.
The VS 130 then runs through the following tests:
•
Test of the sensor head
•
Check of the saved settings and code data
•
If applicable, test of whether data can be exchanged on PROFIBUS (This test
is performed if you have selected "DP" in one or more of the following menus
on the processing unit: Settings > Ports > Result, Settings > Ports > Trigger,
Settings > Ports > Control).
If there are no errors in the self test, either the RUN menu or the STOP menu is
displayed depending on the status when you last shut down.
"RUN" menu:
> C 01 RUN v
=SERIES 7
OK:Menu
Vision Sensor SIMATIC VS 130
A5E00199459-01
"STOP" menu level:
> Train
RUN
Adjust
↓
OK
4-1