Delete" Menu - Siemens SIMATIC VS130 Series Manual

Operator Functions
Menu Entry or Possible Values
Parameter
Messages
ReadErr (user-defined string)
Default:
*Read ERR*|-0D|-0A
FilterMsg (user-defined string)
Default:
*WrongDMC*|-0D|-0A
MatchErr (user-defined string)
Default:
*MatchERR*|-0D|-0A
Prefix Prefix-OK (user-defined string)
maximum length: 101
characters
Suffix Suffix-OK (user-defined string)
Default:|-0D|-0A
maximum length: 101
characters
1)
(|-0D|-0A corresponds to 0D
"Reset All" Submenu
In the "Reset All" submenu, you can change the value of every parameter back to
the default in one action.
5.3.5

"Delete" Menu

With the "Delete" menu, you can delete all the characteristics of the selected code
that were saved during training.
Step Display
1 Adjust
Settings
> Delete
↑
OK
2 Delete
Code: 01?
(trained)
ESC ←↕→ OK
3 Code C 01
Delete?
ESC
5-14
1)
1)
1)
1)
0A , 0D = ASCII code for CR, 0A
H H H
Activity
You are at the "STOP" menu level. Select "Delete" with the arrow
buttons M and L and press "OK".
Select the code number with the arrow buttons M and L and then press
"OK".
•
"(empty)" indicates that there is not yet any trained code with this
number.
•
"(trained)" indicates that you have already trained a code with this
number.
If you press "OK", you delete the saved characteristics of the selected
code.
OK
Meaning
Text for display on the processing unit and for
output over RS-232 or DP if a read error
occurs
Text for display on the processing unit and for
output over RS-232 or DP if the value
selected for "Position" or "ID" in the "Result"
submenu parameter "Filter" does not occur
Text for display on the processing unit and for
output over RS-232 or DP if a comparison
error occurs
String (ASCII) that precedes the characters of
the read code
String (ASCII) that follows the characters of
the read code
= ASCII code for LF)
H
Vision Sensor VS 130
A5E00199459-01