Siemens SIMATIC VS130 Series Manual page 48

Controlling with a PLC
Train Code
The diagram below illustrates an example of the training sequence for code 15.
Note that the trigger signal must be applied for at least 5 ms.
SEL 0
SEL 1
SEL 2
SEL 3
DISA
RES
TRN
TRG
IN_OP
TRD
RDY
Note
After an error has occurred, you must set the signals SEL0 to SEL3 and the signal
TRN to 0 and then reset the error with the RES signal.
6-4
Start training
>200 ms
.
Training complete
Input signals
Output signals
Vision Sensor VS 130
A5E00199459-01