Siemens SIMATIC VS130 Series Manual page 42

Operator Functions
Note
If you want to change the "Match-Opt" parameter from "Position" to "ID", the
processing unit checks all the learned codes to find out whether there is a
sequence that results from the current parameters "MATCH-ID" and separators
from the rules. If this is not the case for one or more learned codes, you have the
following alternatives:
•
You can delete all the learned codes.
•
You can cancel the change in the "Match-Opt" parameter from "Position" to
"ID".
The same applies if you want to change the "Match-Opt" parameter from "ID" to
"Position".
5-12
Vision Sensor VS 130
A5E00199459-01