4.9 Head Height Adjustment
4.9 Head Height Adjustment
This section describes the procedure to check the carriage height (distance from platen).
Jigs and Tools
4.9.1
• PG height adjusting jig (1.1/1.3) : DG-43193
"7.4 Jigs and Tools" p.7-6
Adjustment Procedure
4.9.2
1.
Remove Cariage Cover.
"3.7.2 Removing Carriage Cover" p.3-99
2.
Release Carriage Lock.
"3.7.1 How To Release Carriage Lock" p.3-98
3.
Set the PG height adjusting jigs on the Platen.
CAUTION
Place the head height check jig on the printer head away from the print head nozzle.
Interference may cause damage on print head.
No.
1
Print Head
4.9.1 Jigs and Tools
2
1
Name
No.
2
PG height adjusting jig
4.
Move the carriage from the carriage origin while the lever is set to the "LOW" mode.
5.
Confirm print head go through 1.1 mm step by head hight adjustment jig but not go through 1.3
mm step.
L
1.1mm
No.
1
PG height adjusting jig
2
Print Head
6.
Shift Carriage from the opposite side of Origin and check its height in the same way as in the step
5.
VJ1324E-M-02
Name
2
R
1.3mm
1
Name
P.4-16