Jigs And Tools; Required Tools - MUTOH ValueJet VJ-1324 Maintenance Manual

7.4 Jigs and Tools

7.4 Jigs and Tools
This section provides lists of jigs and tools required for service operations.
7.4.1

Required Tools

(1) Tools for Part Replacement
Table 7-3 Tools for Part Replacement
No. Name Part number
1 Phillips driver No.2 Generic product
2 Phillips driver No.2 Generic product
3 Phillips driver No.1 Generic product
4 Flat-head driver Generic product
5 Box driver Generic product
6 Ratchet Generic product
7 Long-nose pliers Generic product
8 Tweezers Generic product
9 Hex wrench Generic product
(1.5 to 6 mm)
10 Hex wrench Generic product
（2.5mm）
11 E ring holder (E- Generic product
2.5)
12 E ring holder (E-6) Generic product
13 Penlight Generic product
14 Tube cutter Generic product
15 Scale Generic product
7.4.1 Required Tools
Remarks
More than 250 mm shaft length is
recommended.
Less than 50 mm shaft length is
recommended.
-
For replacing E rings
For replacing CR board assemblies
-
-
-
-
For screws retaining Head base.
More than 150mm shaft length and not L-
tyoe are recommended.
Name: JIS E-2.5
Manufacturer: Iwata Denko Co., Ltd
Name: JIS E-6
Manufacturer: Iwata Denko Co., Ltd
-
For replacing solenoid heads and ink tubes
For replacing Steel belt. Longer than 3 meters
is recommended.
(2) Tools for Adjustment
Part
No. Name
number
1 Personal computer Generic
product
2 Network interface Generic
cable product
3 Dedicated network -
software
4 Tension gauge Generic
product
5 Tension gauge Generic
product
6 MF-3G Exclusive
use media
7 PG height adjustment DG-43193
jig(1.1/1.3)
8 level Generic
product
9 Cutter Holder DG-43191
adjustment jig
10 Solenoid Head DG-41787
Washing Kit
11 Solenoid Head DG-41787
Washing Kit(VJ Ink)
VJ1324E-M-02
Remarks
Network interface connector (RJ-45) should
be equipped.
(10M/100M Ethernet I/F)
Cross-type cable
* Use stratight-type cable to connect HUB.
MUTOH Service Assistance
Max. 40 N (4,080gf) for measurement
Manufacturer: Ohba Keiki Seisakusho Co.,
Ltd.
Max. 2N (204gf) for measurement
Manufacturer: Ohba Keiki Seisakusho Co.,
Ltd.
For Paper edge sensor, for print accuracy
adjustment
For adjusting Head height （1.1mm/1.3mm)
For confirming Installation Environment
For assembling Photometer JUNCTION
Board Assy and Cutter Holder
For replacing Solenoid Head Assy
For replacing Solenoid Head.
P.7-6