Setting The Dvr For Pre-Event Recording; Figure 3-47 Pre-Event Setup Screen - Honeywell HRSD40F User Manual

Configuration
9.

Setting the DVR for Pre-Event Recording

When the DVR is in the Event Record mode it is possible to have it record images before
an event occurs. The Pre-Event setup screen allows you to define how to handle
pre-event recording.
Highlight Pre-Event in the Record menu and press
appears.
Turn individual cameras On or Off for pre-event recording by selecting the box next to
the camera and pressing
Set the image speed from 0.10 to 30.00 ips (25.00 ips PAL) by selecting that field and
pressing
Set the image quality by selecting that field and pressing
High, Standard, and Low.
Set the amount of time to record prior to the event by adjusting the Dwell. Choose from
5 seconds to 30 minutes. The longer the dwell time, the fewer maximum ips can be set.
Document 800-03097 Rev C
03/09
Save your changes by highlighting Save and pressing
the screen without saving the changes.
Figure 3-47
. Choose from 0.10 ips to 30.00 ips.
Note When the DVR is in the Time or Time & Event mode, it ignores
the pre-event settings and follows the time settings.
Pre-Event Setup Screen
.
. Select Cancel to exit
. The Pre-Event setup screen
. Choose from Very High,
79