Table of Contents
Advertisement
Command
<percent> An integer, 0 to 100, representing the percentage of storage bins (time buckets)
Example
COMPlete
:ACQuire:COMPlete <percent>
The :ACQuire:COMPlete command specifies how many of the data point storage
bins (time buckets) in the waveform record must contain a waveform sample
before a measurement will be made. For example, if the command
:ACQuire:COMPlete 60 has been sent, 60% of the storage bins in the waveform
record must contain a waveform data sample before a measurement is made.
• If :ACQuire:AVERage is set to OFF, the oscilloscope only needs one value
per time bucket for that time bucket to be considered full.
• If :ACQuire:AVERage is set to ON, each time bucket must have n hits for it
to be considered full, where n is the value set by :ACQuire:AVERage:COUNt.
Due to the nature of real time acquisition, 100% of the waveform record bins
are filled after each trigger event, and all of the previous data in the record is
replaced by new data when :ACQuire:AVERage is off. Hence, the complete
mode really has no effect, and the behavior of the oscilloscope is the same as
when the completion criteria is set to 100% (this is the same as in PDETect
mode). When :ACQuire:AVERage is on, all of the previous data in the record
is replaced by new data.
The range of the :ACQuire:COMPlete command is 0 to 100 and indicates the
percentage of time buckets that must be full before the acquisition is considered
complete. If the complete value is set to 100%, all time buckets must contain
data for the acquisition to be considered complete. If the complete value is set
to 0, then one acquisition cycle will take place. Completion is set by default
setup or *RST to 90%. Autoscale changes it to 100%.
that must be full before an acquisition is considered complete.
This example sets the completion criteria for the next acquisition to 90%.
10
OUTPUT 707;":ACQUIRE:COMPLETE 90"
20
END
Acquire Commands
COMPlete
7-5
Advertisement
Table of Contents
