Agilent Technologies Infiniium 8000A Programmer's Reference Manual page 776

Set the Mode Before Executing Commands
Before executing the :TRIGger:ADVanced:TV:UDTV commands, set the
mode by entering:
:TRIGger:MODE ADVanced
:TRIGger:ADVanced:MODE TV
:TRIGger:ADVanced:TV:MODE UDTV
To query the oscilloscope for the advanced trigger mode or the advanced
trigger TV mode, enter:
:TRIGger:ADVanced:MODE?
:TRIGger:ADVanced:TV:MODE?
You set up the :TRIGger:ADVanced:TV:UDTV commands with the
following commands and queries:
• ENUMber
• PGTHan
• POLarity
• SOURce
When triggering for User Defined TV mode:
• Set the channel or trigger source for the trigger using:
:TRIGger:ADVanced:TV:UDTV:SOURce
• Set the conditions for arming the trigger using:
:TRIGger:ADVanced:TV:UDTV:PGTHan, and
:TRIGger:ADVanced:TV:UDTV:POLarity.
• Set the number of events to delay after the trigger is armed using:
:TRIGger:ADVanced:TV:UDTV:ENUMber
• Set the waveform edge that causes the trigger to occur after arming
and delay using:
:TRIGger:ADVanced:TV:UDTV:EDGE
29-68
and
and
or