Table of Contents
Advertisement
In This Book
This book is your guide to programming the Infiniium Series Oscilloscopes.
Chapters 1-5 give you an introduction to programming the oscilloscopes, along
with necessary conceptual information. These chapters describe basic program
communications, interface, syntax, data types, and status reporting.
Chapter 6 shows example BASIC and C programs, and describes chunks of one
program to show you some typical applications. The BASIC and C example
programs are also shipped on a disk with the oscilloscope.
Chapters 7-25 describe the commands used to program the Infiniium
Oscilloscopes. Each chapter describes the set of commands that belong to an
individual subsystem, and explains the function of each command. These
chapters include:
ACQuire
BUS
CALibration
CHANnel
Common
DIGital
DISK
DISPlay
EXTernal Channel
FUNCtion
HARDcopy
Error Messages chapter describes error messages.
ii
HISTogram
MARKer
MEASure
POD
Root Level
SELFtest
SYSTem
TIMe Base
TRIGger
WAVeform
Waveform MEMory
Advertisement
Table of Contents
