Table of Contents
Advertisement
Function Commands
The FUNCtion subsystem defines functions 1 - 4. The operands of these
functions can be any of the installed channels in the oscilloscope,
waveform memories 1 - 4, functions 1 - 4, or a constant. These FUNCtion
commands and queries are implemented in the Infiniium Oscilloscopes:
• FUNCtion<N>?
• ABSolute
• ADD
• AVERage
• COMMonmode
• DIFF (Differentiate)
• DISPlay
• DIVide
• FFT:FREQuency
• FFT:RESolution?
• FFT:WINDow
• FFTMagnitude
• FFTPhase
• HIGHpass
• HORizontal
• HORizontal:POSition
• HORizontal:RANGe
You can control the vertical scaling and offset functions remotely using
the RANGe and OFFSet commands in this subsystem. You can obtain
the horizontal scaling and position values of the functions using the
:HORizontal:RANge? and :HORizontal:POSition? queries in this
subsystem.
If a channel is not on but is used as an operand, that channel will acquire
waveform data.
If the operand waveforms have different memory depths, the function
uses the shorter of the two.
16-2
• INTegrate
• INVert
• LOWPass
• MAGNify
• MAXimum
• MINimum
• MULTiply
• OFFSet
• RANGe
• SMOoth
• SQRT
• SQUare
• SUBTract
• VERSus
• VERTical
• VERTical:OFFset
• VERTical:RANGe
Advertisement
Table of Contents
