Agilent Technologies Infiniium 8000A Programmer's Reference Manual page 770

STV Commands
These commands set the conditions for the TV trigger mode using
standard, predefined parameters (in STV mode), or user-defined
parameters (in UDTV mode). The STV commands are used for
triggering on television waveforms, and let you select one of the TV
waveform frames and one of the lines within that frame.
Set the Mode Before Executing Commands
Before executing the :TRIGger:ADVanced:STV commands, set the mode
by entering:
:TRIGger:MODE ADVanced and
:TRIGger:ADVanced:MODE TV and
:TRIGger:ADVanced:TV:MODE L525 or
:TRIGger:ADVanced:TV:MODE L625
To query the oscilloscope for the advanced trigger mode or the advanced
trigger TV mode, enter:
:TRIGger:ADVanced:MODE? or
:TRIGger:ADVanced:TV:MODE?
You set up the :TRIGger:ADVanced:TV:STV commands with the
following commands and queries:
• FIELd
• LINE
• SOURce
• SPOLarity
29-62