5
Commands by Subsystem
:BLANk
Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | SBUS}
<n> ::= {1 | 2 | 3 | 4} for the four channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :BLANk command turns off (stops displaying) the specified channel,
math function, or serial decode bus. The :BLANk command with no
parameter turns off all sources.
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
N O T E
commands, :CHANnel<n>:DISPlay, :FUNCtion:DISPlay, or :SBUS:DISPlay are the preferred
method to turn on/off a channel, etc.
MATH is an alias for FUNCtion.
N O T E
See Also
•
•
•
•
•
•
•
Example Code
•
124
(see
page
586)
"Introduction to Root (:) Commands"
":CDISplay"
on page 125
":CHANnel<n>:DISPlay"
":FUNCtion:DISPlay"
":SBUS:DISPlay"
on page 323
":STATus"
on page 149
":VIEW"
on page 152
"Example Code"
on page 152
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 118
on page 180
on page 218