5
Commands by Subsystem
:CALibrate:STARt
Command Syntax
:CALibrate:STARt
The CALibrate:STARt command starts the user calibration procedure.
Before starting the user calibration procedure, you must set the rear panel CALIBRATION
N O T E
switch to UNPROTECTED, and you must connect BNC cables from the TRIG OUT connector
to the analog channel inputs. See the User's Guide for details.
See Also
•
•
170
(see
page
586)
"Introduction to :CALibrate Commands"
":CALibrate:SWITch"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 167
on page 172