Agilent Technologies InfiniiVision 5000 Series Programmer's Manual page 142

5
Commands by Subsystem
Table 40 Overload Event Enable Register (OVL) (continued)
Bit
7
6
5
4
3
2
1
0
Query Syntax
:OVLenable?
The :OVLenable query returns the current enable mask value contained in
the Overload Event Enable Register.
Return Format
<enable_mask><NL>
<enable_mask> ::= integer in NR1 format.
See Also
•
•
•
•
•
•
•
•
•
142
Description
Channel 2 Fault
Channel 1 Fault
---
External Trigger OVL
Channel 4 OVL
Channel 3 OVL
Channel 2 OVL
Channel 1 OVL
"Introduction to Root (:) Commands"
":CHANnel<n>:PROTection"
":EXTernal:PROTection"
":OPEE (Operation Status Enable Register)"
":OPERegister:CONDition (Operation Status Condition Register)"
page 137
":OPERegister[:EVENt] (Operation Status Event Register)"
":OVLRegister (Overload Event Register)"
"*STB (Read Status Byte)"
"*SRE (Service Request Enable)"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
When Set (1 = High = True), Enables:
Event when fault occurs on Channel 2 input.
Event when fault occurs on Channel 1 input.
(Not used.)
Event when overload occurs on External Trigger
input.
Event when overload occurs on Channel 4 input.
Event when overload occurs on Channel 3 input.
Event when overload occurs on Channel 2 input.
Event when overload occurs on Channel 1 input.
on page 118
on page 189
on page 211
on page 143
on page 111
on page 109
on page 135
on page 139
on