Trigger:uart:baudrate - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:TRIGger:UART:BAUDrate

Command Syntax
:TRIGger:UART:BAUDrate <baudrate>
<baudrate> ::= integer in NR1 format
<baudrate> ::= {1200 | 1800 | 2000 | 2400 | 3600 | 4800 | 7200 | 9600
The :TRIGger:UART:BAUDrate command selects the bit rate (in bps) for the
serial decoder and/or trigger when in UART mode.
If the baud rate you select does not match the system baud rate, false
triggers may occur.
Query Syntax
:TRIGger:UART:BAUDrate?
The :TRIGger:UART:BAUDrate? query returns the current UART baud rate
setting.
Return Format
<baudrate><NL>
<baudrate> ::= integer in NR1 format
<baudrate> ::= {1200 | 1800 | 2000 | 2400 | 3600 | 4800 | 7200 | 9600
See Also
•
•
•
430
(see page 586)
| 14400 | 15200 | 19200 | 28800 | 38400 | 56000 | 57600
| 76800 | 115200 | 128000 | 230400 | 460800 | 921600
| 1382400 | 1843200 | 2764800}
| 14400 | 15200 | 19200 | 28800 | 38400 | 56000 | 57600
| 76800 | 115200 | 128000 | 230400 | 460800 | 921600
| 1382400 | 1843200 | 2764800}
"Introduction to :TRIGger Commands"
":TRIGger:MODE" on page 360
":TRIGger:UART:TYPE"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 354
on page 440