Acquire:count - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:ACQuire:COUNt

Command Syntax
:ACQuire:COUNt <count>
<count> ::= integer in NR1 format
In averaging mode, the :ACQuire:COUNt command specifies the number of
values to be averaged for each time bucket before the acquisition is
considered to be complete for that time bucket. When :ACQuire:TYPE is set
to AVERage, the count can be set to any value from 2 to 65536.
The :ACQuire:COUNt 1 command has been deprecated. The AVERage acquisition type with
N O T E
a count of 1 is functionally equivalent to the HRESolution acquisition type; however, you
should select the high-resolution acquisition mode with the :ACQuire:TYPE HRESolution
command instead.
Query Syntax
:ACQuire:COUNT?
The :ACQuire:COUNT? query returns the currently selected count value for
averaging mode.
Return Format
<count_argument><NL>
<count_argument> ::= an integer from 2 to 65536 in NR1 format
See Also
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :ACQuire Commands"
":ACQuire:TYPE" on page 165
":DIGitize" on page 126
":WAVeform:COUNt" on page 450
Commands by Subsystem
on page 153
5
157