Save:setup[:Start] - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

5
Commands by Subsystem

:SAVE:SETup[:STARt]

Command Syntax
:SAVE:SETup[:STARt] [<file_spec>]
<file_spec> ::= {<internal_loc> | <file_name>}
<internal_loc> ::= 0-9; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :SAVE:SETup[:STARt] command saves an oscilloscope setup.
If a file extension is provided as part of a specified <file_name>, it must be ".scp".
N O T E
See Also •
•
•
312
(see page 586)
"Introduction to :SAVE Commands"
":SAVE:FILename" on page 304
":RECall:SETup[:STARt]"
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 303
on page 301