Opt (Option Identification) - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

*OPT (Option Identification)

Query Syntax
*OPT?
The *OPT? query reports the options installed in the instrument. This
query returns a string that identifies the module and its software revision
level.
Return Format
0,0,<license info>
<license info> ::= <All field>,<reserved>,<reserved>,<reserved>,
<All field> ::= {0 | All}
<reserved> ::= 0
<Low Speed Serial> ::= {0 | LSS}
<Automotive Serial> ::= {0 | AMS}
<Secure> ::= {0 | SEC}
<RS-232/UART Serial> ::= {0 | 232}
The *OPT? query returns the following:
Module
No modules attached
See Also •
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
<reserved>,<reserved>,<Low Speed Serial>,
<Automotive Serial>,<reserved>,<Secure>,<reserved>,
<reserved>,<reserved>,<reserved>,
<RS-232/UART Serial>,<reserved>
"Introduction to Common (*) Commands"
"*IDN (Identification Number)"
Commands by Subsystem
Module Id
0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0
on page 93
on page 100
5
103