Timebase Commands - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:TIMebase Commands

Control all horizontal sweep functions. See
Commands"
Table 55 :TIMebase Commands Summary
Command
:TIMebase:MODE
<value> (see
page 345)
:TIMebase:POSition
<pos> (see page 346)
:TIMebase:RANGe
<range_value> (see
page 347)
:TIMebase:REFerence
{LEFT | CENTer |
RIGHt} (see page
:TIMebase:SCALe
<scale_value> (see
page 349)
:TIMebase:VERNier {{0
| OFF} | {1 | ON}}
(see page 350)
:TIMebase:WINDow:POSi
tion <pos> (see
page 351)
:TIMebase:WINDow:RANG
e <range_value> (see
page 352)
:TIMebase:WINDow:SCAL
e <scale_value> (see
page 353)
Introduction to
The TIMebase subsystem commands control the horizontal (X- axis)
:TIMebase
functions and set the oscilloscope to X- Y mode (where channel 1 becomes
Commands the X input and channel 2 becomes the Y input). The time per division,
delay, vernier control, and reference can be controlled for the main and
window (delayed) time bases.
Reporting the Setup
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
on page 343.
Query
:TIMebase:MODE? (see
page 345)
:TIMebase:POSition?
(see page 346)
:TIMebase:RANGe? (see
page 347)
:TIMebase:REFerence?
(see page 348)
348)
:TIMebase:SCALe? (see
page 349)
:TIMebase:VERNier?
(see page 350)
:TIMebase:WINDow:POSi
tion? (see page
:TIMebase:WINDow:RANG
e? (see page
:TIMebase:WINDow:SCAL
e? (see page
"Introduction to :TIMebase
Options and Query Returns
<value> ::= {MAIN | WINDow | XY |
ROLL}
<pos> ::= time from the trigger
event to the display reference
point in NR3 format
<range_value> ::= 10 ns through
500 s in NR3 format
<return_value> ::= {LEFT | CENTer
| RIGHt}
<scale_value> ::= scale value in
seconds in NR3 format
{0 | 1}
<pos> ::= time from the trigger
351) event to the delayed view
reference point in NR3 format
<range value> ::= range value in
352) seconds in NR3 format for the
delayed window
<scale_value> ::= scale value in
353) seconds in NR3 format for the
delayed window
Commands by Subsystem
5
343