Aer (Arm Event Register) - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:AER (Arm Event Register)

Query Syntax
:AER?
The AER query reads the Arm Event Register. After the Arm Event
Register is read, it is cleared. A "1" indicates the trigger system is in the
armed state, ready to accept a trigger.
The Armed Event Register is summarized in the Wait Trig bit of the
Operation Status Event Register. A Service Request can be generated when
the Wait Trig bit transitions and the appropriate enable bits have been set
in the Operation Status Enable Register (OPEE) and the Service Request
Enable Register (SRE).
Return Format
<value><NL>
<value> ::= {0 | 1}; an integer in NR1 format.
See Also •
•
•
•
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to Root (:) Commands"
":OPEE (Operation Status Enable Register)"
":OPERegister:CONDition (Operation Status Condition Register)"
page 137
":OPERegister[:EVENt] (Operation Status Event Register)"
"*STB (Read Status Byte)"
"*SRE (Service Request Enable)"
on page 118
on page 135
on page 111
on page 109
Commands by Subsystem
on
on page 139
5
119