System Requirements - ProSoft MVI56E-MNETCR User Manual

MVI56E-MNETCR ♦ ControlLogix Platform
Modbus TCP/IP Multi-Client Enhanced Communications Module for Remote Chassis
1.2

System Requirements

The MVI56E-MNETCR module requires the following minimum hardware and
software components:

Rockwell Automation ControlLogix
higher), with compatible power supply, and one free slot in the rack for the
MVI56E-MNETCR module. The module requires 800 mA of available 5 Vdc
power

Rockwell Automation RSLogix 5000 programming software
Version 16 or higher required for Add-On Instruction
o
Version 15 or lower must use Sample Ladder, available from
o
www.prosoft-technology.com

Rockwell Automation RSLinx

ProSoft Configuration Builder (PCB) (included)

ProSoft Discovery Service (PDS) (included in PCB)

®
Pentium
recommended

Supported operating systems:
o Microsoft Windows 10
o Microsoft Windows 7 Professional (32-or 64-bit)
o Microsoft Windows XP Professional with Service Pack 1 or 2
o Microsoft Windows Vista
o Microsoft Windows 2000 Professional with Service Pack 1, 2, or 3
o Microsoft Windows Server 2003

128 Mbytes of RAM minimum, 256 Mbytes of RAM recommended

100 Mbytes of free hard disk space (or more based on application
requirements)

256-color VGA graphics adapter, 800 x 600 minimum resolution (True Color
1024  768 recommended)
Note: The Hardware and Operating System requirements in this list are the minimum
recommended to install and run software provided by ProSoft Technology
applications may have different minimum requirements. Refer to the documentation for any third
party applications for system requirements.
Note: You can install the module in a local or remote rack. For remote rack installation, the module
requires EtherNet/IP or ControlNet communication with the processor.
ProSoft Technology, Inc.
®
communication software version 2.51 or higher
II 450 MHz minimum. Pentium III 733 MHz (or better)
®
processor (firmware version 10 or
Start Here
User Manual
. Other third party
®
Page 11 of 161