Unmuting An Input Port; Locking An Input Port; Unlocking An Input Port; Setting The Hdcp State - Lightware MX2-8x8-HDMI20-L User Manual


  
7. LW3 Programmers' Reference
8.5.3. Unmuting an Input Port
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:unmuteSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:unmuteSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:unmuteSource(I1;I3)
Ü mO /MEDIA/XP/VIDEO:unmuteSource=OK
8.5.4. Locking an Input Port
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:lockSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:lockSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:lockSource(I1;I2;I3)
Ü mO /MEDIA/XP/VIDEO:lockSource=OK
8.5.5. Unlocking an Input Port
Command and Response
Ý CALL·/MEDIA/XP/VIDEO:unlockSource(<in>)
Ü mO·/MEDIA/XP/VIDEO:unlockSource=OK
Example
Ý CALL /MEDIA/XP/VIDEO:unlockSource(I1;I3)
Ü mO /MEDIA/XP/VIDEO:unlockSource=OK
MX2-HDMI20 series – User's Manual
8.5.6. Setting the HDCP State
This setting allows to send non-encrypted content to a non-HDCP compliant display. See more information
in the HDCP Management section.
Command and Response
SET·/MEDIA/PORTS/VIDEO/<in>/SETTINGS.HdcpVersion=<HDCP_ver>
Ý
pw·/MEDIA/PORTS/VIDEO/<in>/SETTINGS.HdcpVersion=<HDCP_ver>
Ü
Parameters
Parameter
Identifier
description
<HDCP_ver> HDCP setting
*The availability of this setting depends on the hardware version of the input board (V1x_) of the selected
HDMI port. The hardware version can be found in
Device Info submenu in the LCD.
Example
Ý SET /MEDIA/PORTS/VIDEO/I1/SETTINGS.HdcpVersion=3
Ü pw /MEDIA/PORTS/VIDEO/I1/SETTINGS.HdcpVersion=3
Parameter values
0: HDCP encryption is disabled
1 *: HDCP 1.4 encryption is enabled
2: HDCP 2.2 is enabled
3: High value mode: Any HDCP version is allowed on the input but the
incoming signal is internally converted up to HDCP 2.2 always, thus, the
signal cannot be switched to HDCP 1.4 sinks.
Status Tab in the LDC or in the
58
System Settings Menu,