Operation; Powering On - Lightware MX2-8x8-HDMI20-L User Manual


  

4. Operation

4
O peration
This chapter is about the powering and operating of the device describing the
functions which are available by the front/rear controls:

Powering On

Ý
Front Panel Buttons Operations
Ý
Front Panel LCD Menu Operations
Ý
MX2-HDMI20 series – User's Manual
4.1. Powering On
Connect the power cords to AC input of the Power Supply Units (PSU).
INFO: The router has an internal emergency memory that stores all
current settings and tie configurations. This memory is independent
from presets and invisible for the user. This built-in feature helps
the system to be ready immediately in case of power failure or
accidental power down.
1 RU-high models
The 1 RU-high models are immediately powered on. After the self-test
(about 20 seconds), the router reloads its last configuration and it is
ready to use.
Other models
Certain models are assembled with power button (see the details in
the Model Comparison table).
After switching the power switch to the ON position, the router starts
up. If the mains' switch is in the ON position, then the matrix starts
up immediately when the power cord is connected to the AC source.
During the initial self-test and loading of the latest settings, The matrix
is about to start appears on the LCD screen and the router reloads its
last configuration.
100-240 VAC
2.3-1.1 A 50/60 Hz
INFO: After switching ON, the router reloads the latest settings
that were used before it was switched off. The router has an
internal emergency memory that stores all current settings and tie
configurations.
Redundant Power Supplies
The -R suffix in the model name shows that the model has redundant
PSUs which can be switched on and off without interrupting the video
transmission. Using the only one or both the PSUs at the same time
is also possible.
Double PSU allows to connect them for two different AC power lines
to ensure the continuous power for the matrix.
ON
OFF
17
ON
OFF
ON
OFF