Description - GE ALPS Instruction Manual

10 ALPS TEST PROGRAM
10 ALPS TEST PROGRAM 10.1 INTRODUCTION
ALPS Test is used to generate test data for the measuring units in the ALPS relay for the settings specified by the user. This
data can be used to validate your test data.
In order to run the program, the following files need to be installed in a directory of the tester's choice.
ALPS_TST.EXE
ALPS_TST.INI
ALPS_TST.HLP
PUSHHELP.VBX
Install the program from the GE Power Management Products CD or from the GE Power Management Web site at
www.ge.com/indsys/pm. See Section 11.1.5: SOFTWARE INSTALLATION on page 11–3 for instructions on installing the
ALPS software suite. This installation procedure will install ALPS-TEST along with the ALPS-Set, ALPS-Link, and Xpres-
sion Builder software packages.
The ALPS-Test menus are shown below:
Start the program as in the previous section. When the program is started, the opening screen is displayed.
• The title bar of the main window has the currently opened file name which is the file name the user selected
• Pull down the File menu. The most recent file is this same file name.
GE Power Management
Figure 10–1: FILE AND EDIT MENUS
Figure 10–2: ADDITIONAL ALPS-TEST MENUS
10.1.2 STARTING PROGRAM AFTER THE FIRST TIME
ALPS Advanced Line Protection System
10.1 INTRODUCTION

10.1.1 DESCRIPTION

10
10-1