Entering A Value - GE ALPS Instruction Manual

10 ALPS TEST PROGRAM 10.2 TEST CALCULATIONS

10.2.3 ENTERING A VALUE

Click on a Select button from one of the test dialog boxes (M1 Phase Units – Zone 1 is shown below) for an input quantity
that has a continuous range.
Figure 10–4: INPUT TEST DIALOG BOX: M1 PHASE UNITS – ZONE 1
Select Test Current (amps), the display the Enter Value dialog box. Enter a valid new value and click OK. The dialog box
clears from the screen and the value in the test dialog box is changed to the value just entered.
10.2.4 SELECTING A VALUE
Click on a Select button from one of the test dialog boxes (see above for example) for an input quantity that has a list of val-
ues. An Enter Value dialog box will appear. Select a new value and click on Cancel. The dialog box clears from the screen
and the value in the test dialog box remains unchanged.
Select a new value and click on OK. The dialog box clears from the screen and the value in the test dialog box is changed
to the value just entered.
10.2.5 M1 PHASE UNITS – ZONE 1
The following dialog box is displayed for this test. The values are the default values used when the user selects New Test
File from the File menu.
Figure 10–5: M1 PHASE UNITS – ZONE 1 DIALOG BOX
10
GE Power Management ALPS Advanced Line Protection System 10-3