Table of Contents
Advertisement
14.1 INTRODUCTION
Select OK to create settings for the model number. Verify that the Select Protection Scheme dialog box is displayed:
Note that there is no Cancel button. For new settings, the user must make a scheme selection. Click on the Help button.
This displays the help text for the Select Protection Scheme dialog box.
Select a scheme and click OK. An instruction box provides instructions on changing the selected scheme. For the STEP-
DST scheme, choose the Settings > Protection Settings menu item. The Change Settings – Protection dialog box is
displayed. Individual settings for the scheme selected may now be changed.
•
Only the protection settings that apply to the model number and the firmware version are displayed in the list box.
14
Click on the Change Setting button in the Change Settings – Protection dialog box. This displays the Change Setting
Value dialog box:
•
Each setting may be individually changed by selecting the setting and entering the required value. The range of the
setting is displayed.
•
The help command will give you detailed information about the setting to be changed.
•
If a setting is selected that has specific values, the following dialog box is displayed.
Select Cancel to close the Change Settings – Protection dialog box.
14-2
Figure 14–3: SELECT PROTECTION SCHEME DIALOG BOX
Figure 14–4: CHANGE SETTINGS – PROTECTION DIALOG BOX
Figure 14–5: CHANGE SETTING VALUE DIALOG BOX
ALPS Advanced Line Protection System
14 ALPS-SET PC SOFTWARE
GE Power Management
Advertisement
Table of Contents
