Configuring Measurements And Measurement Series - Siemens SINUMERIK 840D sl Function Manual

03/2013

3.2 Configuring measurements and measurement series

Function description
Configuration of measurements and measurement series it when you define the
parameters required for measurement. The configurations created are always
stored with the measurements and can be used again to repeat the measurements.
That especially applies to measurement series. The configuration of a
measurement series ensures that measurements are made with the same settings
every time. This permits evaluation of the progression of characteristics over time.
In addition to parameters for performing a measurement, the limit values of the
characteristics are also configured. Limit values can be configured for
measurement series. The configuration is only possible on the PC. Individual
measurements that do not belong to a measurement series cannot have limit
values.
Availability and privileges
On the operator panel, a measurement is configured or a measurement series
configuration changed only during the measurement procedure. On the operator
panel, it is only possible to create a measurement series based on a measurement
being performed.
On the PC, it is possible to configure measurement series. The authorization
required to configure measurements and measurement series is described in detail
in the Appendix.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3.2 Configuring measurements and measurement series
3 Setting up functions
3-103