Siemens SINUMERIK 840D sl Function Manual page 174

3 Setting up functions
3.4 Fault Services
Description of "Upload HMI action log" function"
The current HMI action log file can specifically be uploaded to the server with the
trigger event.
This action type has no configurable parameters.
In the column with the paper clip, the HMI action log file can be marked for sending
as an attachment for a notification of the workflow for this control monitor.
Description of the "Upload machine data" function
The diagnostic action "Upload machine data" permits the machine data to be
uploaded to the server upon an event.
This action type has no configurable parameters.
In the column with the paper clip, the machine data can be marked for sending as
an attachment for a notification of the workflow for this control monitor.
Note
The uploaded machine data do not contain any drive machine data.
Description of the "Feedback messages to the PLC" function
The function that provides feedback related to any given trigger event to the PLC
writes individual pieces of information back to the PLC.
For this purpose, four bytes (DBB118, DBB119, DBB120, and DBB121) are
available in DB10 at the interface of the SINUMERIK PLC.
In the SIMATIC PLC, up to 8 bytes are available for this purpose in a freely
configurable DB at any block address. The address range must prepared such that
it is contiguous and has before and after the user area 4 additional bytes in which a
label is to be stored. The label before the user addresses is 'ePS[', and the label
after is ']ePS' , each in ASCII format (corresponding to a hex format of 65, 50, 53,
5B and 5D, 65, 50, 53).
If you also want to use the freely configurable data area in a SINUMERIK, the
same conditions apply as for the SIMATIC. You can select the distribution and
formatting per data byte, word, or double word.
Fig. 3-59: Individual feedback messages to the PLC
3-174
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
03/2013